Thanks to our state-of-the-art bending machines, we are in a position to reliably carry out all bending jobs with the utmost dimensional accuracy. Piece by piece - from start to finish.
The angle sensor system is the key to the bending of high-precision angles. Nominal and set-point values are compared and adjusted, if necessary, by the special in-process control.
In order to avoid distortion of the perforated sheet metal at the bending edges, special dies (“WingBends”) are used.
Trumpf Press Brakes
TruBend 7036
up to 360 kN, up to 1,020 mm bending length
TrumaBend V850
up to 850 kN, up to 2,000 mm bending length
TrumaBend V 3200
up to 3,200 kN, up to 4,500 mm bending length | 
